Cablenet 48 Port Cat5e UTP 1u Patch Panel

LVO233835

72-3407

72-3389

XXFLPP48LC4

LVO233840

Mounted with 6 x LC Duplex Single Mode adapters. 12 pigtails pre-mounted in splice cassette.

Rubber coated strain relief suitable for blown-fibre.

The patch panel have fixtures for splice cassettes and cable management cutouts for securing the cables with cable ties or velcro straps to relieve cable stress.

These 2u Cat6 unshielded UTP Through Coupler Panels are capable of data rates up to 1Gb/sec. They incorporate a removable rear cable management bar and come complete with cable ties. Installation is easy, just plug in your patch leads - no punch down required.

The Cablenet Cat6 UTP 1u high density punch down patch panel with 48 ports in just 1u. Incorporates a rear cable management tray and horizontal dual punch down blocks for LSA or 110.

Termination is easy with detachable upper and lower termination layers. The upper detachable punch down tray is for ports 1 - 24 and the lower section for ports 25 - 48. After termination the top section is simply placed onto the lower section and held in place by two screws.

Coloured markings on punch down blocks and rear labels for correct cable termination.

OM3/4 Multimode Loaded Fibre Patch Panel to accept 48 fibres connecting to 24 LC duplex adaptors.

Capacity can be increased by removing the blanking plugs and replacing with the appropriate adaptor.

The Maxxam Loaded Fibre Patch Panels have been developed to help save time and money when on site. The panels are supplied with the adaptors installed in the front plate and the front plate subsequently mounted on to the panel chassis. The 19-inch mounting brackets are also fitted to the panel chassis so that the panel is ready to be mounted into the rack or cabinet. The panels are supplied with cable glands, bunny clips and splice cassettes and any unused ports are fitted with blanking plugs.

The fibre panels are available with Multimode (OM3 or OM4) or Singlemode adaptors and are configured for 4 to 96 fibres with LC adaptors or 8 to 48 fibres with SC adaptors.

19'' Fibre patch panel for up to 24 SC Simplex or LC Duplex adapters. The panel back side features 4 Ø20 mm inlets suitable for PG screw connection and 2 rectangular inlets 80 x 34 mm with blank plates.

Mounted with 12 x LC Duplex Single Mode adapters. 24 pigtails pre-mounted in splice cassette.

Rubber coated strain relief suitable for blown-fibre.

The patch panel have fixtures for splice cassettes and cable management cutouts for securing the cables with cable ties or velcro straps to relieve cable stress.

24-Port Fibre patch panel mounted with 6 x LC duplex Single Mode connectors

48 Port, 2U, Cat6, UTP, Through Coupler Panel with Marking System

48 Port 1U Cat6 UTP Right Angle Rear EasyPunch Patch Panel

Loaded Fibre Patch Panel, OM4, 48F/24 x LC Duplex

24-Port Fibre patch panel mounted with 12 x LC duplex Single Mode connectors

Lanview

Cablenet

Cablenet

Cablenet

Lanview